8’ Vertical Panel Beam Saw (Manual Stops) | TS-P8V

Features: 

• Precision ground guide rod, made from medium carbon steel coated with hard chrome, provides smooth and accuracy travel.
  
• Three cutting modes: Standard, trim & cutoff to permit clean burrs, repeat cutting mode.
  
• Heavy gauge base frame & table rest is welded from cold rolling steel plate, offers rugged
  construction.
  
• The uniform holding pressure through the entire pressure beam is achieved through a linkage
  mechanism, ensuring synchronized cylinder actuation on both sides.
  
• Flexible saw stroke adjustment enables operator to select the desired stroke either full way or run out panel return depending on panel length to be cut, this reduces considerable cycle time. 
• Fence made of cast iron and surface precision ground is fitted with a flip over stop for
  convenient repetitive cutting.
  
• Dust chute is covered with a split rubber to form a totally enclosed dust collection system, and
  fully prevents the hose from being broken resulting from its fatigue.
  
• The uniform holding pressure through the entire pressure beam is achieved through a linkage
  mechanism, ensuring synchronized cylinder actuation on both sides.
  
• The sectional dust guard not only acts as a surrounding saw blade guard, but also fully prevents
  sawdust from spraying out of the machine.
  
• The saw carriage feed is driven by rugged wire. Fitted with a shock-absorbing cylinder to
  prevent bumping while it travels to the left side.
  
• The scoring blade may be laterally adjusted for a burr-free cut or vertically adjusted for proper
  depth of cut and to compensate for blade wear.
  
• A 1 HP AC motor drives the saw carriage with variable speeds are changed by frequency
  control 16 ~ 98 FPM and retract speed is 98 FPM.
  
• The table surfaces are covered with Bakelite to prevent scratching of the panel during feeding.